Filter
Top Products
24
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
OL-5792-04
Installing and Removing AIMs
Figure 23 Threaded Plastic Standoff
Step 5
Plug the AIM into the AIM connector on the system board. (See Figure 24.) Make sure that the plastic
standoff fits into the hole in the AIM board and that the connector is fully seated.
Step 6
Insert the screws (included in the accessory kit) through the AIM into the metal standoffs. (See
Figure 24.) Tighten the screws carefully with a Phillips screwdriver.
274174
AIM end
Locking end