Filter
Top Products
26
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
OL-5792-04
Installing and Removing AIMs
Step 7
Check that the AIM is installed correctly on the system board. (See Figure 25.)
Figure 25 AIM Installed in AIM Slot 1
Step 8
If you are finished installing modules, install the cover on the router. See the “Installing the Chassis
Cover” section on page 56.
Step 9
Apply the AIM label to the outside of the chassis as described in the “Applying the AIM Label” section
on page 31.
Installing AIM2-CUE-K9 or AIM2-APPRE-104-K9 in a Cisco 2811, Cisco 2821, or Cisco 2851 Router
Cisco 2811, Cisco 2821, and Cisco 2851 routers have two AIM connectors—AIM slot 0 and AIM slot 1.
You can install a virtual private network (VPN) encryption AIM or a voice-mail AIM in either slot, but
not in both slots. You can install voice and data compression AIMs and ATM AIMs in both slots.
Note
Only one AIM2-CUE-K9 or AIM2-APPRE-104-K9 can be installed in a Cisco 2811 router and it must
be installed in AIM slot 0.
Note
The AIM2-CUE-K9 and AIM2-APPRE-104-K9 cannot be used with AIM-IPS modules in the Cisco
2811 router.
72112