Filter
Top Products
16
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
OL-5792-04
Installing and Removing AIMs
Figure 16 Installing a DRAM DIMM
Step 6
If you are finished installing modules, install the cover on the router. See the “Installing the Chassis
Cover” section on page 56.
Installing and Removing AIMs
AIMs plug into an AIM connector on the system board as described in the “Installing an AIM” section
on page 18. Each AIM sold as a spare is supplied with a label that identifies the AIM type. Be sure to
apply the label to the chassis as described in the “Applying the AIM Label” section on page 31.
Before you remove or install an AIM, remove the chassis cover as described in the “Removing the
Chassis Cover” section on page 2.
Caution
When you remove or install an AIM, always wear an ESD-preventive wrist strap, and ensure that it
makes good contact with your skin. Connect the equipment end of the wrist strap to the metal part of the
chassis.
1 Insert the DRAM DIMM 2 Close the latches
103467
2
2
1
Ta b l e 1 AIMs Supported on Cisco 2800 Routers
Cisco Part Number Type
AIM-ATM= ATM
ATM- COMP R2- V2= Compression
AIM-CUE= Unity Express
AIM2-CUE-K9 Unity Express
AIM2-APPRE-104-K9 AXP - Application eXtension Platform
AIM-IPS Intrusion Prevention Systems
AIM-VPN-EPII-PLUS VPN Encryption