Filter
Top Products
8-14
Catalyst 2940 Switch Software Configuration Guide
78-15507-02
Chapter8 Configuring 802.1X Port-Based Authentication
Configuring 802.1X Authentication
This example shows how to set 60 as the number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before resending the request:
Switch(config-if)# dot1x timeout tx-period 60
Setting the Switch-to-Client Frame-Retransmission Number
In addition to changing the switch-to-client retransmission time, you can change the number of times
that the switch sends an EAP-request/identity frame (assuming no response is received) to the client
before restarting the authentication process.
Note You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Beginning in privileged EXEC mode, follow these steps to set the switch-to-client frame-retransmission
number. This procedure is optional.
To return to the default retransmission number, use the no dot1x max-req interface configuration
command.
This example shows how to set 5 as the number of times that the switch sends an EAP-request/identity
request before restarting the authentication process:
Switch(config-if)# dot1x max-req 5
Configuring the Host Mode
You can configure an 802.1X port for single-host or for multiple-hosts mode. In single-host mode, only
one host is allowed on an 802.1X port. When the host is authenticated, the port is placed in the authorized
state. When the host leaves the port, the port becomes unauthorized. Packets from hosts other than the
authenticated one are dropped.
You can attach multiple hosts to a single 802.1X-enabled port as shown in Figure 8-3 on page 8-5. In
this mode, only one of the attached hosts must be successfully authorized for all hosts to be granted
network access. If the port becomes unauthorized (re-authentication fails or an EAPOL-logoff message
is received), all attached clients are denied access to the network.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and specify the interface to be
configured.
Step 3
dot1x max-req count Set the number of times that the switch sends an EAP-request/identity
frame to the client before restarting the authentication process. The range
is 1 to 10; the default is 2.
Step 4
end Return to privileged EXEC mode.
Step 5
show dot1x interface interface-id Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.