Filter
Top Products
6-8
Cisco Active Network Abstraction 3.6.6 MPLS User Guide
OL-19192-01
Chapter 6 IPv6 VPN over MPLS
Provisioning Route Targets
If a prefix length is not explicitly specified, it is calculated as the number of furthest left significant bits
in the subnet address.
Provisioning Route Targets
Cisco ANA 3.6.6 allows you to create VRF route targets and assign IPv4 and IPv6 address families to
them using one of the following methods:
• In the Cisco NetworkVision device logical inventory, right-click a VRF and choose Add Route
Target (see Figure 6-4).
Figure 6-4 Adding Route Target Using Cisco ANA NetworkVision
• From Command builder, launch a route target with address family command (Figure 6-5).
1 Logical inventory 2 VRFs
3 Commands option 4 Add Route Target command
1
2
3
4