Filter
Top Products
6-9
Cisco Active Network Abstraction 3.6.6 MPLS User Guide
OL-19192-01
Chapter 6 IPv6 VPN over MPLS
Provisioning Route Targets
Figure 6-5 Command Builder Route Target Commands
Note To assign address families to VPN communities, the VRF must have been created with the vrf definition
Cisco IOS command. Address families cannot be assigned to VRFs created with the ip vrf command.
After you launch the Cisco ANA NetworkVision or Command Builder command, the Add Route Target
Import With Address Family or Add Route Target Export With Address Family dialog box appears
(Figure 6-6). The dialog box contains an Input tab and a Results tab. The Input tab is where you enter
the VPN community (either import or export), route target, and address family.