Filter
Top Products
Total Number of Entries = 1
To get more detail about the multicast groups, use this command:
Coriolis> (enable) show multicast group [vlan]
CGMP disable
IGMP enable
VLAN Dest MAC/Route Des Destination Ports or VCs / [Protocol Type]
———— —————————————————— ——————————————————————————————————————————
1 01−88−75−88−08−57* 2/1−12
1 11−87−96−54−22−11* 2/1−12
Total Number of Entries = 2
Again, if you only want to see the entries that were learned from IGMP, you can use the command show
multicast group igmp [vlan].
Configuring CGMP
CGMP is disabled by default. Use the following command to enable CGMP:
Coriolis> (enable) set cgmp enable
CGMP support for IP multicast enabled.
Disabling CGMP
To disable CGMP, use the following command:
Coriolis> (enable) set cgmp disable
CGMP support for IP multicast disabled.
Enabling CGMP Fast−Leave Processing
To enable CGMP fast−leave processing, enter the following command:
Coriolis> (enable) set cgmp leave enable
CGMP leave processing enabled.
Disabling CGMP Fast−Leave Processing
To disable CGMP fast−leave processing, enter the following command:
Coriolis> (enable) set cgmp leave disable
CGMP leave processing disabled.
Displaying CGMP Statistics
To display CGMP statistics, use the following command:
Coriolis> (enable) show cgmp stat
CGMP enabled.
CGMP statistics for vlan 1:
valid rx pkts received 12548
invalid rx pkts received 0
valid cgmp joins received 12865
valid cgmp leaves received 147
154