Filter
Top Products
To identify an MPS with a specific name, use the following command:
mpoa server config name mps−name
1.
The ATM address that specifies the control ATM can be optionally identified using this command:
atm−address atm−address
2.
To specify the network ID, use the following command:
network−id id
3.
To identify a keepalive time value, use the following command:
keepalive−time time
4.
To change the holding−time value, use the following command:5.
holding−time time
Monitoring the MPS
To monitor the MPS, use the following command in Privileged EXEC mode:
show mpoa server
Enabling ILMI Autoconfiguration
The following example shows how to enable Integrated Local Management Interface (ILMI)
autoconfiguration on interface ATM 3/1/2:
CoriolisLS1010(config)# interface atm 3/1/2
CoriolisLS1010(config−if)# atm auto−configuration
CoriolisLS1010(config−if)#
%ATM−5−ATMSOFTSTART:Restarting ATM signaling and ILMI on ATM3/1/2
Configuring LANE on a LightStream 1010
To configure a LANE client connection from a remote ATM switch router to the processor card (CPU) of a
local switch, follow these configuration steps:
Use the enable command to enter Privileged EXEC mode:
CoriolisLS1010> enable
1.
Use the config terminal command to enter Global Configuration mode:
CoriolisLS1010# config terminal
2.
Enter Subinterface mode for the processor card using the following
command:
CoriolisLS1010(config)# interface atm 0[.subinterface]
3.
You must specify an ATM address to override the automatic ATM address assigned to a LANE
client:
CoriolisLS1010(config−if)# lane client−atm−address atm−address−template
4.
194