Filter
Top Products
IF−Side: Network IF−type: NNI
Uni−type: not applicable Uni−version: not applicable
CoriolisLS1010#
Viewing the Configured Virtual Connections
To view the configured virtual connections, use the show atm vp command as shown here:
CoriolisLS1010# show atm vp
Interface VPI Type X−Interface X−VPI Status
ATM3/0/2 2 PVP TUNNEL
CoriolisLS1010#
Configuring the LECS ATM Address on a LightStream 1010
Switch
To configure the LAN Emulation Configuration Server (LECS) ATM address on a LightStream 1010 switch,
follow these steps:
Use the enable command to enter Privileged EXEC mode.1.
Use the config terminal command to enter Global Configuration mode.2.
Enter Interface Configuration mode for the correct ATM interface.3.
Use the atm command followed by the address of the LECS:4.
atm lecs−address atm−address
Tip To verify the address configuration, use the show atm ilmi−configuration command.
Configuring the Advertised LECS Address
To configure the LECS address advertised by the switch to the end system, use the atm lecs−address−default
Global Configuration command. The syntax is as follows:
atm lecs−address−default lecsaddress [sequence #]
Related solutions: Found on page:
Configuring a LEC for an ELAN 271
Configuring the LECS 273
Viewing the LANE Configuration
To view the LANE configuration on a LightStream series switch, use the show lane command as follows:
CoriolisLS1010# show lane
LE Server ATM2/0.2 ELAN name: elan1 Admin: up State: operational
type: ethernet Max Frame Size: 1516
ATM address: 47.0091810000000060707B8A01.1122334455AA.02
LECS used: 47.0091810000000060707B8A01.0060705A8F05.00 connected, vcd 1450
191