Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-5. Disassembly, Reassembly and Lubrication
3-37 CL-S700/CL-S703/CL-S700R
(3) Removing the “Door, Rewinder” and “SA1, Peeler”
1. Remove the Rewinder Mechanism block referring to above “(2) Removing the Rewinder
Mechanism block”.
Note: To remove the “Door, Rewinder” alone, it is not necessary to detach the Rewinder
Mechanism block. You can remove it after opening the Rewinder cover.
2. Remove 4 screws (PHT (#2), M3x6) and detach the “Frame2, Door Center”.
3. Remove 4 screws (PHT (#2), M3x6) and detach the Handle and Rewinder Door.
Note on reassembling:
• When attaching the “Door, Rewinder”, run the Peel sensor cable along the door frame
as shown in the figure (See the “Cable path”).
4. Remove 2 screws (PH (SW+PW), M3x5) and detach the “SA1, Peeler”.
Note on reassembling:
• Pass the cable (J503) through the left opening “A” as shown in the figure.
Door, Rewinder
Handle
SA1, Peeler
PH (SW+PW), M3x5
PHT (#2), M3x6
PHT (#2), M3x6
PHT (#2), M3x6
(To J503)
(To J504)
(Cable path)
(Cable path)
Frame2, Door Center
A