Filter
Top Products
Chapter 4 Troubleshooting
4-2. Troubleshooting
CL-S700/CL-S703/CL-S700R 4-10
Symptoms Checks Remedies
Ribbon end is not
correctly detected.
1. Is the connector of the ribbon encoder
in the “Unit, Frame Ribbon L” firmly
connected to the “SA, Main PCB” (J8)?
2. Ribbon encoder is defective.
3. Failure in the control circuit.
1. Connect it firmly.
2. Replace the “Unit, Frame Ribbon
L”.
After replacement, perform ribbon
tension adjustment referring to
“3-6-4. Ribbon Tension
Adjustment” in Chapter 3.
3. Replace the “SA, Main PCB”.
Label on liner or
notch of tag is not
detected.
(Transparent sensor
problem)
Or
Paper end is not
detected.
1. Is the Media Sensor menu setting
correct?
2. Is the Adjustable Sensor positioned to
an appropriate position where label or
notch of tag can be detected? (When
adjustable sensor is to be used)
By default, the Sensor Select menu is
set to “Rear Adj Sensor” and the
Adjustable Sensor is selected”.
3. Is the sensor adjustment performed
against media to be used?
4. Is the following connector of the “SA,
Sensor U” firmly connected to the “SA,
Main PCB”?
For Adjustable Sensor: J7
For Front Fixed Sensor: J6
5. Is the following connector of the “SA,
Sensor Bottom” firmly connected to the
“SA, Main PCB”?
For Adjustable Sensor: J22
For Front Fixed Sensor: J21
6. Is dust on the LED of the Transparent/
Reflective Sensor?
8. Failure in the Transparent Sensor or the
Reflective Sensor.
9. Failure in the control circuit.
1. Set it to “See Through”.
2. Move the Adjustable Sensor by
turning the adjustable sensor
position knob.
3. Perform the sensor adjustment for
user. See “Sensor Adjustment for
user (Transparent Sensor/
Reflective Sensor)” on the next
page.
4. Connect it firmly.
5. Connect it firmly.
6. Clean the LED to remove dust.
8. Replace the “SA, Sensor U” or the
“SA, Sensor Bottom”.
9. Replace the “SA, Main PCB”.