Filter
Top Products
Compaq Deskpro 1000 Series of Personal Computers 5-11
5.10.1 Installing a SIMM Module
CAUTION:
Static electricity can damage the electronic components or optional equipment. Before
beginning these procedures, ensure that you are discharged of static electricity by briefly touching a
grounded metal object.
CAUTION
: When handling a memory module, be careful not to touch any of the contacts. Doing so may
damage the module.
1. Perform preparation procedures (Section 5.4).
2. Remove the system unit cover (Section 5.5).
3. Insert a memory module at a 45-degree angle into a SIMM socket on the system board 1.
✎
A memory module can be installed only one way. Match the notch on the module
with the tab on the memory socket. Push the module down into the socket,
ensuring that the module is fully inserted and properly seated.
Figure 5-10
Installing a SIMM Module
4. Rotate the module to an upright position, allowing the latches to snap into place 2.
5. Repeat steps 3 and 4 for each module that you want to install.
6. Replace the system unit cover.
7. Plug in the computer power cord.
8. Turn on the computer.
✎
The computer recognizes system memory upgrades and automatically reconfigures
the computer. If, for some reason, the memory upgrades do not configure
correctly, run the CMOS Setup Utility to reconfigure the computer. See Chapter 7,
“Utilities,” for information running the CMOS Setup Utility.
9. Test the system (optional) using a diagnostics software.
✎
Diagnostics software is not included with this computer. Compaq diagnostics
software, Version PC 10.25A, is available from the Compaq world-wide web site
at www.compaq.com. Third-party diagnostics software is also available.