Filter
Top Products
5-26 Removal and Replacement Procedures
5.19.3 3.5-Inch Drive
Before beginning the removal procedure, ensure that all removal media have been removed from
the drive.
CAUTION:
When servicing this computer, ensure that the cables are placed in their proper locations
during the reassembly process. Improper cable placement can damage the computer.
1. Perform preparation procedures (Section 5.4).
2. Remove the system unit cover (Section 5.5).
3. Remove the drive cage (Section 5.19.2).
4. Remove the two screws on each side of the drive (four total) that secure the drive in the drive
cage.
5. Pull the 3.5-inch drive straight out of the drive cage.
Figure 5-22.
Removing a 3.5-Inch Hard Drive from the Drive Cage
To replace the 3.5-inch drive, reverse the previous procedure.