Filter
Top Products
Compaq Deskpro 1000 Series of Personal Computers 5-13
5.11 Power Supply
1. Perform preparation procedures (Section 5.4).
2. Remove the system unit cover (Section 5.5).
3. Remove the power connector cables from the system board.
4. Disconnect the power cables from the drives.
5. Remove four screws from the power supply on the rear of the chassis.
6. Remove one screw securing the power supply to the inside of the chassis.
7. Lift the power supply up until it hits the lip of the chassis.
8. Slide the power supply towards the front, and lift it out of the chassis.
Figure 5-12.
Removing the Power Supply
To replace the power supply, reverse the previous procedure.