Power on
14 RP90 Plus E and RL90 User Guide
Power on the laminator
When the optional RL90 laminator is
installed, turn the laminator power on
before powering on the printer.
1 Press the “|" symbol on the
laminator power switch.
2 The laminator powers on. The
LCD panel displays
"Initializing" and the green
Ready light blinks.
3 "Preheating" is displayed for
approximately four minutes
while the heat roller warms to
operating temperature.
4 The LCD panel shows "Ready" and the Ready light is steady green
when the laminator is ready to process cards.
LCD sequence on laminator startup
Tips for laminator power
• When connected to a
printer, laminator
messages will not be
displayed until the
printer is powered on.
• Wait while the laminator
initializes.
• Follow the guidelines for
your organization about
when to power the
laminator on and off.
• Check that the red
INLET switch, located
on the back of the
laminator, is set for your
input voltage.