Filter
Top Products
66
HR Cam Heater Cam error. Turn the power switch off, and then back on. Contact
your service provider if this does not correct the
condition.
Heater Err The heater temperature
does not increase.
Check that the voltage inlet switch, located on the
back of the laminator, is in the proper position for the
input voltage. Contact your service provider if this
does not correct the condition.
HR Overheat Heat roller temperature is
too high.
Turn the unit off and contact your service provider
before powering back on.
Temp Sensor The heat roller
temperature sensor is not
working.
Turn the unit off and contact your service provider
before powering back on.
Memory Err There is an internal
memory error.
Turn the unit off and contact your service provider
before powering back on.
Set Temp Err There is an error with the
heat temperature setting.
Turn the unit off and contact your service provider
before powering back on.
R. Encoder Err Rotary encoder error. Turn the unit off and contact your service provider
before powering back on.
Overheat The temperature inside the
unit is too high.
Turn the unit off and contact your service provider
before powering back on.
PRT. Communicate Communication error with
the printer.
Check that the laminator cable is connected securely
to the printer.
Turn the printer and laminator off, and then back on to
recycle the power.
Film Exchanged? The patch or topcoat
material was changed
while the laminator was
turned off.
Press the RESET/K and then the ENTER key to
initialize the patch or topcoat material.
LCD Message Possible Cause Solution