Filter
Top Products
54 Mini Tower Computer
10
If you installed a network adapter card and want to turn off the integrated network adapter:
a
Enter system setup, select
Integrated NIC
from the
Onboard Devices
group, and change the
setting to
Off
(see "System Setup" on page 257).
b
Connect the network cable to the network adapter card’s connectors. Do not connect the network
cable to the integrated network connector on the back panel of the computer.
11
Install any drivers required for the card as described in the card documentation.
Removing PCI Express x16 Cards and DVI-Cards
1
Follow the procedures in "Before You Begin" on page 19.
2
Gently lift the release tab on the card retention latch from the inside to pivot the latch open. Pivot the
latch until it snaps into the open position.
3
If necessary, disconnect any cables connected to the card.
4
Press the lever with your thumb until you release the securing tab.
If you are removing a PCI Express x16 card, go to step 5.
If you are removing a DVI-card, go to step 6
5
While pressing the lever, pull the card up and out of the card connector.
1 PCI Express x16 card 2 lever 3 securing slot
4 securing tab 5 PCI Express x16 card
connector
3
2
1
5
4