Filter
Top Products
IOM Slot A1 IOM Slot A2 NIC3 and NIC4
(Enabled/Disabled)
Port Auto-Disablement
Empty Quad or Greater Port Enabled Inactive
Dual Port Empty Disabled Active
Dual Port Dual Port Disabled Active
Dual Port Quad or Greater Port Enabled Inactive
Quad or Greater Port Empty Enabled Inactive
Quad or Greater Port Dual Port Enabled Inactive
Quad or Greater Port Quad or Greater Port Enabled Inactive
Mezzanine Cards
PowerEdge M610x Only
PowerEdge M610x supports two mezzanine cards. Mezzanine cards can be installed in both the slots on
the midplane interface card.
NOTE: PowerEdge M610x is a full-height blade but supports only two mezzanine cards in the
expansion bay. The two mezzanine slots on the M610x system board (MEZZ2_FAB_B and
MEZZ1_FAB_C) are reserved for the mezzanine interface card.
Full-Height Blades
Full-height blades support four mezzanine cards:
• Slot Mezz1_Fabric_C and slot Mezz3_Fabric_C support Fabric C. They must match the fabric type of
the I/O modules installed in I/O module slots C1 and C2.
• Slot Mezz2_Fabric_B and slot Mezz4_Fabric_B support Fabric B. They must match the fabric type of
the I/O modules installed in I/O module slots B1 and B2.
Half-Height Blades
Half-height blades support two mezzanine cards:
• Mezzanine card slot C supports Fabric C. This card must match the fabric type of I/O modules
installed in I/O module slots C1 and C2.
• Mezzanine card slot B supports Fabric B. This card must match the fabric type of I/O modules
installed in I/O module slots B1 and B2.
The following table shows various supported combinations of mezzanine cards and I/O modules.
Table 2. Supported I/O Module Configurations
Fabric A Fabric B Mezzanine
Card
Fabric C Mezzanine
Card
I/O Bay A1,
A2
I/O Bay B1,
B2
I/O Bay C1,
C2
Standard
Integrated
LOM
None None Ethernet
switch
module or
pass-
None None
39