Filter
Top Products
3. Slide the module out of the enclosure.
4. Install the I/O connector cover.
Figure 47. Removing and Installing a CMC Module or iKVM Module (CMC Module Shown)
1. I/O connector cover 2. release latch
3. release lever
Installing An iKVM Module
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Remove the I/O connector cover.
2. Open the iKVM module handle.
3. Slide the module into the enclosure until the handle contacts the enclosure.
4. To fully seat the module, close the handle until the release latch snaps into place.
5. If applicable, connect the keyboard, monitor, and mouse to the module.
I/O Modules
CAUTION: If you remove an I/O module, you must either replace it with another I/O module or
with a filler blank to maintain cooling airflow through the system enclosure.
88