Filter
Top Products
Configuration: About Your Storage Array 79
To configure alert notifications for a single storage array:
1
In the EMW, select the
Devices
tab.
2
Select the relevant storage array, then select
Edit
Configure
Alerts
.
The
Configure Alerts
dialog is displayed. To configure e-mail alerts, see
"Configuring E–mail Alerts" on page 79. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 81.
Configuring E–mail Alerts
For more information on configuring alert notifications, see "Configuring
Alert Notifications" on page 78.
To configure e-mail alerts:
1
Open the
Configure Alerts
dialog by performing one of these actions:
• In the Tree view or the Table view on the
Devices
tab in the EMW,
select a node, and then select
Edit
Configure Alerts
. Go to step 3.
•In the
Setup
tab in the EMW, select
Configure Alerts
. Go to step 2.
2
Select one of the following radio buttons to specify an alert level:
•
All storage arrays
—Select this option to send an alert e-mail about
events on all storage arrays.
•
An individual storage array
—Select this option to send an alert e-mail
about events that occur on only a specified storage array.
These results occur, depending on your selection:
• If you select all storage arrays, the
Configure Alerts
dialog appears.
• If you select an individual storage array, the
Select Storage Array
dialog appears. Select the storage array for which you want to receive
e-mail alerts and click
OK
. The
Configure Alerts
dialog appears.
• If you do not know which storage array to select, click
Blink
to turn on
the LEDs of the storage array.
3
In the
Configure Alerts
dialog, select the
Mail Server
tab.
4
In
Mail server
, type the name of the Simple Mail Transfer Protocol
(SMTP) mail server.
The SMTP mail server is the name of the mail server that forwards the
alert e-mails to the configured e-mail addresses.
book.book Page 79 Wednesday, June 8, 2011 5:01 PM