Filter
Top Products
80 Configuration: About Your Storage Array
5
In
E-mail sender address
, type the e-mail sender address. Use a valid e-
mail address.
The e-mail address of the sender (the network administrator) appears on
each e-mail alert sent to the destination.
6
To include the contact information of the sender in the e-mail alert, select
Include contact information with the alerts
, and type the contact
information.
NOTE: Including the contact information in the e-mail alert is optional.
7
Select the
e-mail
tab to configure the e-mail destinations.
• Adding an e-mail address—In
e-mail address
, type the e-mail address,
and click
Add
.
• Replacing an e-mail address—In the
Configured E-mail addresses
area, select the e-mail address to be replaced, type the replacement e-
mail address in
E-mail address
, and click
Replace
.
• Deleting an e-mail address—In the
Configured E-mail addresses
area,
select the e-mail address, and click
Delete
.
• Validating an e-mail address—Type the e-mail address in
E-mail
address
or select the e-mail address in the
Configured E-mail
addresses
area, and click
Test
. A test e-mail is sent to the selected e-
mail address. A dialog with the results of the test and any error
appears.
8
For the selected e-mail address, in
Information To Send
, select:
•
Event Only
—The alert e-mail contains only the event information.
This alert type is the default.
•
Event + Profile
—The alert e-mail contains the event information and
the storage array profile.
•
Event + Support
—The alert e-mail contains the event information
and a compressed file that contains complete support information for
the storage array that has generated the alert.
book.book Page 80 Wednesday, June 8, 2011 5:01 PM