Filter
Top Products
Inside The Blade
Figure 7. Inside the Blade
1. blade system board release handle 2. mezzanine card blank
3. processor/DIMM blank 4. LOM riser card connector
5. heat sink (for processor 1) 6. memory modules (3) (for processor 2)
7. SSD backplane 8. solid state drives (2)
9. SD card 1 slot 10. SD vFlash card/SD card 2 slot
11. processor 2 socket 12. memory modules (3) (for processor 1)
13. optional mezzanine card (Fabric B or C) 14. mezzanine card release latch
I/O Module Mezzanine Card
Mezzanine Card Installation Guidelines
• The blade supports one SFF mezzanine card.
• The mezzanine card slot supports Fabric B or Fabric C, depending on the slot in the sleeve where the
blade is installed. This card must match the fabric type of the I/O modules installed in the
corresponding I/O module bays.
NOTE: For more information on I/O modules, see "Guidelines for Installing I/O Modules" in the
M1000e Enclosure Owner's Manual at support.dell.com/manuals.
29