Filter
Top Products
b. Grasp the cable on both sides of the cable connector, and pull the cable up and away from the
PERC card.
5. Angle the card so that the other end of the card disengages from the storage-controller card holder
on the system board.
6. Replace the storage controller card and connect the cable. For more information on installing the
card, see Installing the PERC 9 mini monolithic controller.
7. Close the system.
8. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
Figure 8. Removing and installing the PERC 9 mini monolithic card
1. storage controller cable 2. storage controller card
3. storage-controller card holder 4. storage controller retention hook
Replacing the battery of a H730P mini monolithic card
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
42