Dell UCPA-901 Computer Hardware User Manual


 
6. Slide the battery carrier in the direction of the arrow printed on the battery carrier, and then flip the
battery carrier open.
7. Remove the battery from the PERC card.
Figure 19. Removing the battery
1. PECR FD33xD card 2. battery carrier
3. battery cable 4. battery
8. Install the replacement battery on the controller.
9. Push the battery carrier toward the battery and slide the battery carrier till it clicks into place.
10. Connect the battery cables to the PERC card.
11. Replace the PERC card. For more information, see Installing the PERC FD33xD card.
12. Close the system.
13. Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
Installing the PERC FD33xD card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: PERC FD33xS and FD33xD cards are supported only on PowerEdge FD332 system. The
procedure for installing a PERC FD33xS card is identical to installing a PERC FD33xD card.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
56