Filter
Top Products
CAUTION: To prevent damage to the card, you must hold the card by its edges only.
5. Align the following:
a. screw holes on the PERC 9 mini blade controller with the standoffs on the system board
connector.
b. slots on the PERC 9 mini blade controller edge with the tabs on the support bracket.
6. Lower the PERC 9 mini blade controller onto the connector on the system board.
7. Tighten the two retention screws on the hard-drive/SSD backplane cable connector to secure the
card on to the system board.
8. Install the tethered battery cable, if applicable.
9. Close the clamp.
10. Install the NDC riser.
11. Close the system.
12. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
Removing the PERC FD33xD Card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: PERC FD33xS and FD33xD cards are supported only on PowerEdge FD332 system. The
procedure for removing a PERC FD33xS card is identical to removing a PERC FD33xD card.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on
components in the interior of the system.
2. Open the system.
3. Locate the PERC card.
4. Loosen the screws securing the cable to the PERC card.
5. Lift the cable away from the PERC card by holding the cable touch point.
6. Holding the touch point, allow the cable to slowly retract into the cable coil.
7. Remove the screws securing the PERC card to the PERC card holder.
8. Holding it by the touch points, lift the PERC card from the connector on the midplane interface
module.
54