A list of physical disks is displayed. The status of each disk is displayed under the heading State.
2. Press the down-arrow key to highlight a physical disk that is in failed state.
3. Press <F2> to display a menu of available actions.
The Rebuild option is highlighted at the top of the menu.
4. Press the right-arrow key to display the rebuild options and select Start.
5. After you start the rebuild, press <Esc> to display the previous menu.
NOTE: You can also use the VD Mgmt screen to perform a manual rebuild. Use the arrow key
to highlight a physical disk, and press <F2>. In the menu that is displayed, select the Rebuild
option.
Controller Management
Enabling boot support
NOTE: See your system documentation to ensure the proper boot order is selected in the system
BIOS.
In a multiple controller environment, you can enable BIOS on multiple controllers. However, if you want
to boot from a specific controller, enable the BIOS on that controller and disable it on the other
controllers. The system can then boot from the BIOS-enabled controller. Perform the following steps to
enable the controller BIOS:
1. Press <Ctrl> <N> to access Ctrl Mgmt menu screen.
2. Press <Tab> to move the cursor to Enable Controller BIOS in the Settings box.
3. Press the spacebar to select Enable Controller BIOS.
An X is displayed beside Enable Controller BIOS.
4. Press <Tab> to move the cursor to the Apply button, and then press <Enter> to apply the selection.
The controller BIOS is enabled.
To disable the controller BIOS, use the spacebar to de-select the Enable Controller BIOS control,
and then select Apply and press <Enter>.
Enabling boot support for a BIOS-enabled controller
1. Press <Ctrl> <N> to access the Ctrl Mgmt menu screen.
2. Press <Tab> to move the cursor to the Select Boot Device in the Settings box.
3. Press the down-arrow key to display a list of virtual disks.
4. Use the down-arrow key to highlight a virtual disk.
5. Press <Enter> to select the disk.
6. Press <Tab> to move the cursor to the Apply button, and then press <Enter> to apply the selection.
Boot support is enabled for the selected controller.
82