Filter
Top Products
DSL-524T ADSL Router Manual
30
Step 2.2: Static IP Address
Figure 3-7. Set RFC2684 Bridged Static IP window
VPI/VCI
If you are told to change the VPI or VCI values, type in the values given
to you by your service provider. Many users will be able to use the
default settings.
IP Address
Enter the IP address based on the information provided to you by your ISP.
Subnet Mask
Enter the Subnet Mask based on the information provided to you by your ISP.
ISP Gateway
Address
Enter the Default Gateway based on the information provided to you by your ISP.
Primary DNS
Address
This entry is for the IP address of your primary domain name server, which should also
be provided to you by your ISP. The router will first try the Primary DNS Address to
resolve a website’s URL IP address. If this IP address fails, the router will then try the
Secondary DNS Address.
Secondary DNS
Address
The IP address of the secondary domain name server will be used to resolve a
website’s URL IP address if the Primary DNS Address fails. The information in this
field should also be provided by your ISP.
Connection Type
There are four Connection Types set in the router to be chosen by using the pull down
menu and they are 1483 Bridged IP LLC, 1483 Bridged IP VC-Mux, 1483 Routed IP
LLC, 1483 Routed IP VC-Mux and IPoA. The correct choice should be told to you by
your ISP.
The following window is used to set the Static
IP mode for the Router. A Static IP address is
used whenever a known static IP is assigned.
The accompanying information such as the
Subnet mask, ISP Gateway Address and
DNS servers should also be specified in order
to be able to connect. These are the servers
would enable you to have access to other
web servers. Valid IP addresses range from
1.0.0.1 to 255.255.255.255.
To configure the connection for Static,
perform the steps listed below. Some of the
settings do not need to be changed the first
time the device is set up, but can be changed
later if you choose. After setting the values
listed, click the Next button to go to Step 3 of
the Configuration Wizard.