DSL-524T ADSL Router Manual
37
Figure 4- 1. Home – WAN window
ATM VC Setting
The first section of the WAN configuration pages offers fields to set general values for any Virtual
Channel chosen for connection to your ISP. This section holds the following fields to configure.
PVC: Leave this set at the default value 1 the first time the Router is set up. The modem has been pre-
configured for 7 PVCs. The PVC for you should be enabled when you have made your first
connection to the Internet. The configured settings for this can be viewed under the Status tab, under
Device Info.
VPI: If instructed to change this, type in the VPI value for the initial connection.
VCI: If instructed to change this, type in the VCI value for the initial connection.
Virtual Circuit: This enables the PVC connection on your modem. Select Enable from the pull down
menu to enable the selected PVC.
WAN Settings
The WAN Settings section of this window will allows users to select the type of connection to be used
by the router to establish a connection between you and your ISP. Choosing a WAN type will change