Filter
Top Products
Fast Ethernet Switching System User’s Guide
Installing the DES-5200
19
Power On
The power supply will adjust to the local power source automatically. The DES-
5200 may be plugged in without having any or with all LAN segment cables
connected.
The power plug is located at the rear of the DES-5200. Plug the cable into the
wall socket and plug the other end into the DES-5200. There is a power on/ off
switch located at the rear of the DES-5200. Move the switch to the on position to
power the DES-5200 on. The power LED will light and all ports will auto
negotiate the proper speed and duplex mode.
Reboot the DES-5200 if there is a problem. Contact D-Link Systems, Inc. for
technical support. Check the configuration of the DES-5200 after a power failure
but do not reset unless it is necessary.
The DES-5200 can be used with power sources in the range 100 to 240 VAC., 50
to 60 Hz.