Filter
Top Products
Installation Instructions IM581127000
Spec. No. 581127000 (Model 710NPBA) Issue AB, March 22, 2012
Chapter 5. Installing the Modules and Initially Starting the System Page 91
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Figure 5-2
Handle/Latch Operation on the Rectifier and DC-DC Converter Modules
Procedure
1) Unpack the modules.
2) Note the model number located on the handle of each module. Model numbers
starting with the letter “R” (R24-2500 or 24-3000) are rectifiers. Model numbers
starting with the letter “C” (C24/48-1500) are DC-DC converter modules.
3) Check the module location diagram on the front of the shelf to determine which
type of module (rectifier or DC-DC converter) can be installed in each mounting
position. See Figure 5-1.
4) If present, remove blank cover panels from the mounting positions into which
rectifier or DC-DC converter modules are to be installed.
5) Place the module into an unoccupied mounting slot without sliding it in
completely.
6) Loosen the captive screw on the module handle. Pull the handle to pivot it out of
the module front panel (this will also retract the latch mechanism located at the
right side of the module). See Figure 5-2.
7) Push the module completely into the shelf.
8) Push the handle into the front panel of the module. This will lock the module
securely to the shelf. Tighten the captive screw on the handle.
9) Repeat the above steps for each module being installed in the system.
10) After the modules are physically installed in the mounting shelf(s), they are ready
for operation immediately after power is supplied to them.