Filter
Top Products
Using the CORFIX Program
To configure your computer for use with the RampagePlus 286
memory card, you need to use CORFIX, an Epson utility on
your Reference diskette, and SMART, the RampagePlus 286
setup program. You must use CORFIX before you use SMART.
If you have a hard disk, you can copy the CORFIX program
from your Reference diskette to your hard disk before you run
the program. See “Copying the Reference and Utility Files” in
Chapter 3 for more information. Then follow the
instructions
below to run the CORFIX program from your hard disk.
Follow these steps to run the CORFIX program:
1.
If necessary, turn on your computer. Make sure the
MS-DOS command prompt appears on your screen.
If you do not have a hard disk, insert your
Reference
diskette in drive A and turn on the computer. At the
Operation Menu, select Exit to MS-DOS for
more utilities
and press
Enter.
If necessary,
type A:
and press Enter to log onto drive A.
2.
At the C> or A> prompt, type CORFIX and press Enter.
The following messages appear:
The program will configure the
system to work with the SMART
utility when installing the Rampage
plus 286.
SMART can only be executed
immediately after this configuration
program. Continue ? (Y/N)
Installing and Removing Options
5-37