Filter
Top Products
FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protections against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
l
Reorient or relocate the receiving antenna
l Increase the separation between the equipment and the receiver
l Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected
l Consult the dealer or an experienced radio/TV technician for help.
You may find the following booklet prepared by the Federal Communications
Commission helpful: “Television Interference Handbook.” This booklet is available
from the U.S. Government Printing Office, Washington, DC 20402.
Stock No. 004-000-00450-7.
Note: If the interference stops, it was probably caused by the computer or its periph-
eral devices. To further isolate the problem:
Disconnect the peripheral devices and their input/output cables one at a time. If the
interference stops, it is caused by either the peripheral device or its I/O cable. These
devices usually require shielded I/O cables. For Epson peripheral devices, you can
obtain the proper shielded cable from your dealer. For non-Epson peripheral devices,
contact the manufacturer or dealer for assistance.
WARNING: This equipment has been certified to comply with the limits for a
Class B computing device, pursuant to Subpart B of Part 15 of FCC Rules. Only
peripherals (computer input/output &vices, terminals, printers, etc.) certified to
comply with the Class B limits may be attached to this computer. Operation with
noncertified peripherals is likely to result in interference to radio and TV
reception.
The connection of a nonshielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels
that exceed the limits established by the FCC for this equipment. It is the
responsibility of the user to obtain and use a shielded equipment interface cable
with this device. If this equipment has more than one interface connector, do not
leave the cables connected to unused interfaces.
DOC COMPLIANCE STATEMENT FOR CANADIAN USERS
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the radio interference regulations of the Canadian
Department of Communications.
Conformation
1
Les
Normes
dIEmission
Radioelectriques Canadiennes
Le
present appareil numerique n’emet
pas
de bruits radioelectriques depassant
les
limites applicables aux appareils numeriques de Classe
B
prescrites dans le reglement
sur
le
brouillage
tadiohlectriques
&cc&
par
le
Minist&re
des
Communications du
Canada.