Filter
Top Products
INSTALLING THE INTERFACE KIT
Make sure that the machine is unplugged before you have the interface kit installed.
The installation must be carried out by a qualified service technician.
CONNECTION TO THE COMPUTER
There is no cable provided with the printer interface kit. To connect the printer to your
computer, you will need either:
❐ A cable for the parallel channel, also known as a Centronics cable.
❐ A cable for the serial channel, also known as a null modem RS-232C cable.
If you plan to connect two computers, you will need one of each.
Make sure that the computer and the printer are both switched off and unplugged
before connecting or disconnecting the cable at either end.
Cables should not be longer than 2.5 metres [about 8 feet].
When connecting the printer to your computer, determine which channel you will be us -
ing. Some computers only provide one type of channel. If your computer has both
types, use the parallel channel, leaving the serial channel free for other devices, such
as modems. If you are in doubt about which type of connection to use, consult your
dealer.
INSTALLATION
Font Car-
tridge Slot
(on the side
of the ma-
chine)
Font/Emulation
Card Slot
Connector for the Serial
Channel
Connector for the Par-
allel Channel
7