Filter
Top Products
An INSUFF MEMORY message appears and graphics cannot be printed
❐ Change the FULL PRINT setting (see page 29) or the RX-BUFFER setting (see
page 37).
❐ Your printer may not have enough memory. Simplify the page or install additional
memory (see page 10). To clear the error, press .
❐ If you are set up in CH INDIVIDUAL mode, check that the memory share is set up
so that the channel used for printing complex pages has a large enough share of the
memory. See page 38 for how to share the memory between channels in
INDIVIDUAL mode.
PROBLEMS WITH SELECTYPE MODE
Selectype does not function as expected
Settings made with Selectype are ignored
❐ Your computer software may be changing the printer’s settings or initializing the
printer. You may have to change the initialization sequence sent by the software.
See your software manual for more information. Anyway, you should be able to
make any required printer setting by configuring the software package correctly.
❐ You may have made a combination of settings using Selectype mode that your
printer cannot act upon. Normally, the printer checks for such incompatible settings,
but some combinations may elude the checking procedure. Try a different combina -
tion of settings.
❐ You may not have saved your settings before turning off the printer. For Level 1 set -
tings, use the SAVE MACRO and POWERON MACRO routines (see pages 31 and
33). For Level 2 settings, use the P-CONFIG SAVE routine (see page 41).
❐ You may have saved settings to the same macro number in more than one channel.
Never save settings to the same macro number for more than one channel. If you
used macro 1 for the serial channel, do not store a macro 1 for the parallel channel;
the settings in one channel may affect the settings in another.
The desired Selectype settings are not displayed
❐ You may be trying to select a setting that is not available in the current emulation
mode. The available settings are not the same for each emulation mode. Also, some
settings are not displayed if you have not installed certain items of optional equip -
ment, such as font cartridges.
❐ You may have entered the wrong Selectype level. See the lists on pages 21 and 22
to find out what level your setting is in.
SOLVING PROBLEMS
51