Filter
Top Products
7. twice to return to printer standby mode.
The following table shows the maximum setting that you will need for each paper size.
Your machine may not be able to use all these paper sizes; check the specifications
section in your fax machine’s operator’s manual.
Paper Size Setting
A4 51
Letter 47
Legal 62
- MEMORY LEFT -
Use this feature to display the amount of memory available . This helps you to check
whether a newly-installed memory option is working properly, or to see how much mem -
ory is available for fonts or complex graphics.
1. Enter SYSTEM CONFIG mode (see page 29).
2. , then or until MEMORY LEFT is dis -
played. In this case, there is 219 K.
3. After checking the display press three
times.
- T-OFFSET and L-OFFSET -
These allow you to make fine adjustments in the position of the printed image on the
page.
❐ T-OFFSET allows you to raise or lower the printing position by up to about 5 mm
[0.2 inch]. T-OFFSET is the distance relative to the top of the page.
❐ L-OFFSET allows you to move the printing position to the left (negative values) or to
the right (positive values) by up to about 5 mm [0.2 inch]. L-OFFSET is the distance
relative to the left edge of the page.
Available Settings: -64 to +63 dots. Each dot is about 0.0846 mm [1/300 inch]. For ex -
ample, a setting of "1" for T-OFFSET will move the print area down by 1/300 inch.
The following example procedure shows how to adjust the L-OFFSET feature.
The T-OFFSET feature is similar in operation.
1. Enter SYSTEM CONFIG mode (see page 29).
ADJUSTING THE PRINTER SETTINGS
30