Filter
Top Products
The printer is initially set up for the parallel channel. If your computer has a parallel
channel, you should be able to connect it up with a properly shielded, twisted pair ca -
ble and use it without having to change any of your printer’s settings.
If you have to use a serial channel, you may also need to adjust some of the serial
channel settings, such as Baud rate (see page 36), to match your computer’s settings.
If you plan to connect a computer to each channel, see page 13.
TESTING THE PRINTER
The printer has two built-in tests: the status sheet, and the test print. These tests let
you check the operation of your printer and obtain information on printer settings.
Printing a Test Page
1. Function 3 5 Yes
2. Hold down until the display is as shown on
the right. Then release it immediately.
Note: If you did not hold down for long
enough, press twice, then repeat
step 2.
3. Hold down or until the display is as
shown on the right.
4.
5. Select either the vertical lines test pattern ("1"
is displayed) or the horizontal line test pattern
("2" is displayed).
Use or to select the test pattern.
When the correct one is displayed, press .
The machine prints a test pattern.
6. Press twice to return to printer "Ready"
mode.
7. Press Function to leave printer mode.
INSTALLATION
8