Filter
Top Products
PAPER SIZE ERROR
The PAGE SIZE setting does not match the paper in the selected cassette. Press to
clear the error. Then either load the correct size of paper in the cassette, or change the
PAGE SIZE setting (see page 27 or use your application software).
PRINTING
The printer has received data and is printing. Please wait.
PRINT STOP x/y
The printer is pausing during a multi-copy printout. Please wait; printing should soon re -
sume automatically. ’x’ represents the current page number, and ’y’ shows the number
of copies currently set in the COPIES setting (see page 27).
READY: {x} {mode}
The printer is ready to print. ’x’ shows the current printer channel and ’mode’ shows the
current printer mode. This is the printer "Ready" mode.
REINSERT CARD
You may have removed a card while the indicator was still lit or while the printer
was on line. To correct the error, make sure the printer is off line. Then reinsert the card
or cartridge and press .
REMOVE CARD
You may have inserted a card/cartridge when the indicator was on or while the
printer was on line. To correct this error, take the printer off line, then remove the card
or cartridge, then press . Before you reinsert the card or cartridge, make sure that all
the data in the buffer has been printed and that the printer is off line. If the indicator
is on, press to print out the remaining data.
RESET: {x} {mode}
The printer has been reset to the settings stored in the macro number that is currently
specified with the LOAD MACRO setting (see page 32). ’x’ shows the current printer
channel and ’mode’ shows the current printer mode.
SAVE MEMORY OVERFLOW
This message may appear while you are trying to save a macro with the SAVE
MACRO routine (see page 31). However, the printer does not have enough mem ory to
store the macro. Delete any unused macros using the DELETE MACRO routine (see
page 33), then repeat the SAVE MACRO routine.
SERVICE REQ. xxxxx
A controller or printer engine error has been detected. ’xxxxx’ is the error code. Write
down the error code then switch off the printer. Turn the printer back on after a few sec -
onds. If the error message still appears, turn off the printer and unplug it, then call your
service representative.
SOLVING PROBLEMS
46