Filter
Top Products
Example Procedure: To change the Baud rate to 4800.
1. Enter Level 2 mode (see page 34).
2. Press or until I/F CONFIG. is displayed.
3.
4. Press or until CH S CONFIG. is dis -
played.
5.
6. Press or until BAUDRATE is displayed.
7. To change the current setting:
8. Press or until the required setting is dis -
played.
9. Store the displayed setting:
10. four times to return to printer "Ready"
mode.
RX-BUFFER SIZE (Receive Buffer Size)
This feature allows you to change the size of the printer’s input buffer. A larger buffer al -
lows you to quickly transfer data from the computer’s memory to the printer’s memory.
The printer then prints the data from its own memory, and the computer’s memory is
free for other tasks.
The settings that are available depend on how much printer memory you have installed
in your printer. Memory used for fax communication (SAF memory, ECM memory) is
not included. If you have no additional memory for your printer, the factory setting is 5
KB.
If you set the buffer size too high for the amount of memory that you have installed,
you may get an error message telling you to add memory.
If your document is larger than the buffer, the computer must wait for the printer to buff -
er, format, and print the page.
1. Enter Level 2 mode (see page 34).
ADJUSTING THE PRINTER SETTINGS
37