Filter
Top Products
EPSON Stylus PHOTO RX600/610, RX620/630 Revision C
Troubleshooting Troubleshooting for Printer 31
Printer stops during initialization
Table 3-11. Diagnostics when printer stops during format
Condition Cause Check Point Remedy
Printer error is indicated. Faulty PE sensor Check PE sensor signal level.
(Refer to Table 3-22 “Sensor Check” on page -35)
Replace the PE sensor
Faulty CR HP sensor Check CR HP sensor signal level.
(Refer to Table 3-22 “Sensor Check” on page -35)
Head FFC is not connected properly. Check whether Head FFC is connected properly. Connect the Head FFC
Faulty CR motor Check whether CR motor cable is connected properly. If there is no problem with cable connection, replace the CR
motor.
Check whether the internal coil resistance is just as specified
and whether the harness is connected properly.
See
Table 3-21 “Motor Resistance and Check Point” (p 35).
Replace the CR motor.
Faulty PF motor Check whether PF motor cable is connected properly. If there is no problem with cable connection, replace the PF
motor.
Check whether the internal coil resistance is just as specified
and whether the harness is connected properly. See Table 3-21
“Motor Resistance and Check Point” (p 35).
Replace the printer mechanism or PF motor.
CR lock is not undone. Check whether no gear is damaged in the PF motor torque
transmission route.
Replace the damaged gear with a new one.