Filter
Top Products
EPSON Stylus PHOTO RX600/610, RX620/630 Revision C
Disassembly and Assembly Overview 37
4.1 Overview
This section describes procedures for disassembling the main components of the
product. Unless otherwise specified, disassembly units or components can be
reassembled by reversing the disassembly procedure.
WARNING
Things, if not strictly observed, that could result in injury or loss of life are
described under the heading “WARNING”.
CAUTION
Precautions for any disassembly or assembly procedures are described under the
heading “CAUTION”.
CHECK
Chips for disassembling procedures are described under the heading “CHECK
POINT”.
REASSEMBLY
If the assembling procedure is different from the reversed procedure of the
disassembling, the procedure is described under the heading “REASSEMBLY”.
ADJUSTMENT REQUIRED
Any adjustments required after disassembling the units are described under the
heading “ADJUSTMENT REQUIRED”.
When you have to remove any units or parts that are not described in this chapter, refer
to the exploded diagrams in the appendix.
Read precautions described in the next section before starting.
4.1.1 Precautions
See the precautions given under the handling “WARNING” and “CAUTION” in the
following column before disassembling and assembling the product.
W A R N I N G
Disconnect the power cable before disassembling or assembling
the printer.
If you need to work on the printer with power applied, strictly
follow the instructions in this manual by paying attention in
order not to get electric shock.
Wear protective goggles to protect your eyes from ink. If ink
gets in your eye, flush the eye with fresh water and see a doctor
immediately.
Always wear gloves for disassembly and re-assembly to avoid
injury from sharp metal edge.
If ink is fitted to skin, flush it out with water and soup. If
inflammation is caused to skin, see a doctor.
To protect sensitive microprocessors and circuitry, use static
discharge equipment, such as anti-static wrist straps, when
accessing internal components.
To prevent consumables form explosion or ignite, do not put it
near fire or throw it into fire.
If developing fluid or oil are fitted to skin or clothes, remove
them completely with waste cloth and wash cleanly with water.