Filter
Top Products
Power Supply
Problem
Solution
Power is not being
supplied to the
printer.
After turning on
the printer, the
display panel
remains blank.
The printer turns
on briefly, but then
the dispIay goes
blank and the
printer motor and
fan stop running.
The power cable may be disconnected or
may not be completely plugged into the
electrical outlet. Turn off the printer and
check the power cable connections
between the printer and the electrical
outlet; then turn the printer back on.
The problem may be with the electrical
outlet itself. If the outlet is controlled by
an outside source such as a wall switch,
make sure it is on.
If the printer still does not operate, the
outlet may be faulty. Plug another
electrical device into the outlet to check
whether the outlet is operating properly.
The voltage may not be correct for your
printer. Turn off the printer and make sure
that the voltage of your electrical outlet
matches the rating indicated on the label at
the back of the printer. If the voltages
match, try turning on the printer again.
If the voltages do not match, disconnect
the power cable and contact your dealer
immediately.
Troubleshooting 7-17