Filter
Top Products
Testing the Printer
If the start page prints correctly, you can skip to the section on
connecting the printer to your computer later in this chapter. If the
start page does not operate properly, see Chapter 7 for
troubleshooting information.
Adjusting print density
You can control the overall density of the printed image with the
print density control knob. If your test print is too light or too
dark, adjust the print density as follows:
1.
Lift the latch to open the printer cover to the lower position.
2.
Locate the yellow density control knob inside the front right
corner of the printer, as shown below.
Testing and Connecting Your Printer
2-13