Filter
Top Products
50 Solving Problems
The power light does not come on.
Make sure the power cord is connected securely both at the power
outlet and the projector. If you have just replaced the lamp, make sure
the cover is securely fastened.
The lamp warning light is red or flashing red.
Replace the lamp as described on page 42.
The lamp warning light is flashing orange.
The lamp is almost burned out. Make sure you have a replacement
lamp ready.
The temperature light is flashing orange.
■ The projector is too hot, and is in a high-speed cooling cycle.
Make sure the room temperature does not exceed 95 °F (35 °C)
and there is plenty of space around and under the projector for
ventilation.
■ The air filter may be clogged. Clean or replace it as described on
page 40.
The temperature light is red.
■ The projector is overheating, which turns the lamp off
automatically. Wait until the cooling fan stops, then unplug the
power cord. Plug the power cord back in and press the
Power
button. Make sure the room temperature is not above 95 °F
(35 °C) and there is plenty of space around and under the
projector for ventilation.
■ The air filter may be clogged. Clean or replace it as described on
page 40.
■ If the projector continues to overheat after you clean the air filter,
the problem may be caused by damage to the cooling fan or
temperature sensor. Contact EPSON for help.
Refer to the following table for a complete description of the
projector’s status lights and their meaning.
warning
Except as specifically
explained in this
User’sGuide, do not
attempt to service the
p
rojector yourself.