Filter
Top Products
Solving Problems 51
Status lights
Light Status Description
orange The projector is in standby mode. You can press the Power button to
turn it on, or turn it off with the power switch on the back.
flashing green The projector is warming up. Wait for the image to appear.
green The projector is operating normally.
flashing red or
orange
The projector is cooling down. Do not turn off the main switch on the
back or unplug it until the light stops flashing. If you want to turn the
projector back on, you can press the Power button if the light is
flashing orange or is solid orange. You cannot turn it on if the light is
flashing red.
red
flashing red
flashing red
Power is cut off because of an internal problem. Remove the power
cord and contact your dealer for help.
flashing orange The lamp is almost burned out. Make sure you have a replacement
lamp ready.
red
red
The lamp is burned out. Replace it as described on page 42.
flashing orange The projector is too hot and is in cooling mode. Make sure the
temperature surrounding the projector does not exceed 95
°F (35 °C)
and there is plenty of space around and under it for ventilation. Clean
the air filter if necessary. See page 40 for instructions.
red
red
The projector is overheating, which turns off the lamp automatically.
Let it cool for five minutes, then turn it back on. Make sure there is
plenty of space around and under the projector for ventilation. If it
continues to overheat, you may need to change the air filter. See
page 40 for instructions.
red
flashing red
The lamp was not cooled down properly. The main power switch was
turned off before the projector cooled down the last time it was used,
and then the projector was turned back on before one hour. Turn off
the projector, wait 2 minutes, and when the fan stops, turn off the
main switch. Wait another 2 minutes, then turn the projector back on.
red
flashing red
There is a problem with the cooling fan or temperature sensor. Turn
off the projector and unplug it. Contact your dealer for help.