Epson TW100 Projector User Manual


 
66 Appendix B: Notices
Never push objects of any kind through the cabinet slots. Never spill
liquid of any kind into the projector.
Except as specifically explained in this Users Guide, do not attempt to
service this product yourself. Refer all servicing to qualified personnel.
Opening or removing covers may expose you to dangerous voltages and
other hazards.
Unplug the projector during lightning storms or when it will not be used
for extended periods.
Do not place the projector and/or remote control on top of
heat-producing equipment or in a hot location.
Unplug the projector from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
When the power cord or plug is damaged or frayed.
If liquid has been spilled into the projector, or if it has been exposed
to rain or water.
If it does not operate normally when you follow the operating
instructions, or if it exhibits a distinct change in performance,
indicating a need for service.
If it has been dropped or the housing has been damaged.
If you use the projector in a country other than where you purchased it,
use the correct power cord for that country.
Do not stand on the projector or place heavy objects on it.
Do not use the projector outside of the required temperature range of
41 to 95 °F (5 to 35 °C). Doing so may cause an unstable display and
could lead to projector damage.
Do not store the projector outside of the required temperature range of
14 to 140 °F (10 to 60 °C) or in direct sunlight for long periods of
time. Doing so may cause damage to the case.
The projector contains many glass parts such as the lens and projection
lamp. The lamp is fragile and can easily break. If the lamp breaks, handle
the projector very carefully to avoid injury from broken glass, and
contact your dealer or service representative for repair. Be careful to
avoid getting pieces of glass in the eyes or mouth.
Be particularly careful if the projector is installed against the ceiling, as
small pieces of glass may fall down when the lamp cover is removed.
Never try to remove the lamp immediately after use, as this will cause
serious burns. Follow the instructions in Chapter 3 to replace the lamp.