Filter
Top Products
4 • Using ELP Link IV
102
Installing the Software
ELP Link IV software can be used with the following operating
systems:
❐
Windows 3.x
❐
Windows 95 or 98
❐
Windows NT 3.51 or 4.0
❐ Macintosh OS System 7.5.1 and OS System 8.x.
Connecting Needed Cables
Before installing the ELP Link IV software, make sure the projector is
properly connected to your computer with the main and serial cables.
See Chapter 1 for instructions.
Installing the Software for Windows
Follow these steps to install ELP Link IV for Windows 3.x,
Windows 95 or 98, or Windows NT:
1. Turn on your computer and start Windows.
2. Insert the Projector Software CD into your CD-ROM drive.
3. If you have Windows 95, 98, or NT, the ELP Link IV Setup
window should open automatically. If if doesn’t, click Start and
then Run. The Run dialog box appears. Type E:\SETUP
(substitute the correct drive letter for your CD-ROM drive if it is
not E), then press Enter or click OK.
80009000.book Page 102 Monday, November 1, 1999 9:35 AM