Filter
Top Products
Connecting to a Video Source
53
You can connect the projector to an S-Video source, a composite video
source, and a component video source at the same time. However, the
projector automatically selects the S-Video as the video source.
The projector supports HDTV, NTSC, PAL, and SECAM video
formats, and automatically detects and identifies the video format.
However, you can specify that a single broadcast format be detected.
(See Chapter 3.) Note that the projector will then be able to detect
only one type of video signal.
The type of cable you use to connect the video source to the projector
depends on whether you have composite video, S-Video, or
component video. For composite video, use the RCA audio and RCA
video cable supplied with the projector. For S-Video, use the S-Video
cable supplied with your video device or obtain one from your
computer or video equipment dealer. For component video, use the
BNC type cable that came with your video source. The illustration
below shows the S-Video, component, and composite connectors.
4
2
3
1
S-Video
4-pin, mini-DIN
component
BNC connector
composite
RCA
80009000.book Page 53 Monday, November 1, 1999 9:35 AM