Filter
Top Products
1 • Setting Up the Projector
26
1. Connect the round end of the main cable to the projector’s
Mouse/Com 1 port. (Use the Mouse/Com 2 port if you are
connecting a second computer.)
2. To use the remote control as a wireless mouse, connect the PS/2
mouse or USB cable included with the projector to the MOUSE
terminal on the square end of the main cable.
3. Disconnect your mouse from the mouse port on the back of your
computer and replace it with the other end of the PS/2 mouse or
USB cable. (Your computer’s mouse will be disabled while you are
using the remote control as a mouse.)
Note: If your system uses a serial mouse, perform steps 2 and 3 using
the PC mouse serial cable instead of the PS/2 mouse or USB cable (not
shown in the illustration).
80009000.book Page 26 Monday, November 1, 1999 9:35 AM