Filter
Top Products
Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©
Page 66 www.PressureSystems.com
Command 'c'— Sub-command Index 02: Stop Stream
This sub-command is used to abort (or temporarily suspend) the delivery of any previously
started host stream in a module, one at a time or all together, whether the stream was
“continuous” or “limited” duration. The sub-command’s format is:
Command
“c 02 st”
‘c’ is the command letter.
‘ 02’ is the sub-command index (ii) for Stop Stream.
‘ st’ is the stream id digit (1, 2, or 3, or 0=all streams).
NOTE: all parameters are separated by a space.
Response
“A”
‘A’ is the acknowledge letter
Autonomous
Packet
command stops generation of autonomous packets from the requested
stream(s).
Description: This sub-command stops the current “run” of a particular specified host stream
(st=1-3); or stops the current “run” of “all configured” host streams with a single
command (st=0).
The stopped stream may be resumed for any new “runs” with the Start Stream
sub-command, as long as that stream remains defined in the module. The Clear
Stream sub-command may be used to un-define a stream. Any stream must
first be reconfigured with the Configure A Host Delivery Stream sub-command
(00) to be fully restartable with the Start Stream sub-command (i.e., to start
again with sequence number = 1 for run’s first packet).
Example:
● Stop all the streams configured in the previous example:
“c 02 0”
Read response:
"A"