Filter
Top Products
HTML Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • HTML Operation
6-14
PRELIMINARY
Create a tie
Select and switch an input as follows:
1. Click the Video Only, Audio Only, or Video & Audio button to select video,
audio, or both for switching (audio follow or audio breakaway). Each mouse
click on a button toggles the other two buttons off.
2. Move the mouse over the matrix of input and output selection buttons. Click
a button to create a preliminary tie (if not tied) or preliminary untie (if tied)
of the input and output associated with that button. A “P” (for preliminary)
appears in the button.
N
If you lose track of the input and output associated with a specifi c button, let the
mouse rest over one of the tie buttons for a moment. A fi eld pops up (as shown
on fi gure 6-10) that identifi es the input and output for that button.
N
To tie an input to all outputs, click that input’s input number.
3. Click the Take button to make the confi guration changes or Cancel button to
abandon the confi guration changes.
RGBHV and Audio Settings page
The RGBHV and Audio Settings page provides a way to set the input audio gain
and attenuation, set the output volume, mute and unmute all video and audio
outputs, and (for systems with CrossPoint 450 Plus sync BMEs only) set the
RGB delay (switching interval). Access the RGBHV and Audio Settings page
(fi gure 6-11) by clicking the RGBHV & Audio Settings link on the Control page.
N
The control options on this page vary, depending on the confi guration of the
matrix switcher system.
Select Ties 1 through 32
Select Global Presets
Refresh
Select Ties 33 through 64
Figure 6-11 — RGB and Audio Settings page